: Is there a simple way to test the safety relay?
Eventually, when the water got up to temp, i could run hot water trough the group, water dispenser, and steam wand, but the pressure gauge has not budged (it says it should be between .9-1.2 Bar). The pump would pull the water from the reservoir just fine. After running a few ounces through it, the machine shuts off. I waited about 20 minutes and fired it up again and the same thing - runs for a few ounces with hot water, and then shuts off. It seems like there is pressure even though the gauge is stuck. I am able to get water out of the water dispenser and water/steam out of the steam wand. When I was descaling, I used a blind basket and was able to get some pressure at the group head and a little bit of water kicked out of the 3-way valve at the bottom. Thanks
Content Management Video